Visitors

©2019 by PT. Virence Optoelektronik Prima

The closest isolated MCPCB performance to copper Direct Thermal Path MCPCB. The dielectric thermal conductivity used may seem low in performance at only 7,5 W/MK. But it's ultra thin 10µm (0,01mm) thickness makes the thermal resistance superior to the brittle and expensive Aluminun Nitride which needs much more thickness to be reliable. The dielectric layer also will not delaminate even when the solder mask already damaged unlike most other non DTP boards.

 

This 16mm board designed specifically for 15 watt quad-trix Nichia E17A/E21A. Also compatible with Cree XD16.

 

Features:

  • Direct access to each LED for multi colour application.
  • Configurable to 3V, 6V, 9V, and 12V to suit almost any applications and broader driver selections.
  • Very high performance beyond what can be achieved compared to normal isolated non DTP MCPCB in such a compact footprint.
  • Paired with 4 x E21A can be overdriven up to 35 watt (with proper cooling).

Link: http://budgetlightforum.com/node/51021

 

MCPCB's general specifications:

  • MCPCB thickness: 1,65mm ±0,1mm
  • Dielectric thickness: 20µm ±3µm
  • Dielectric thermal conductivity: 7,5W/MK
  • Copper trace: 35µm for better reflow process
  • Solder mask thickness: 15µm ±5µm
  • Anode – cathode gap: 0,2mm
  • Final quadtrix footprint: slightlyadjustable from 4,4 × 4,4mm to 4,6mm x 4,6mm.
  • Bright reflective white solder mask
  • Very thin solder mask for minimum solder bond line
  • Copper pads plating: OSP to get every last bit of thermal performance
  • Routed outline, not punched to get the flattest possible bottom.

-----

NOTE:

  • For manual reflow we strongly suggest Pb63Sn37 solder paste. Poorer wetting of leadfree solder paste requires precise dispensing and LEDs placement.
  • The ultra thin solder mask/solder resist is somewhat fragile, especially in hot temperature during reflow process. Avoid any hard and sharp objects on it.
  • Solder mask is rated to survive multiple reflows up to 300°C only for a brief moment (< 30 seconds). Prolonged high temperature exposure above 240°C will make it less white while still functional
  • Soldering LED wire can be difficult because the board is very thermally conductive.
  • Fixes: Use more powerful solder iron with as big as possible tip, pre-heat the base (or the case/host), use intermediate wire (solder a short slave wire to the pad first).

VR16SP4

$3.00Price
  • For additional cost, we can solder any suitable LED(s) on the MCPCB. Please buy the LED(s) first and then buy the soldering service. We'll reflow the MCPCB using LED in your cart.

     

    Use the product picture and leave the instruction in the "special instruction" field (optional). Check here

0

MY CART